BMT-F-AOP4 BACnet MS/TP

Description

The BACnet MS/TP module with 4 analog outputs was developed for decentralized switching tasks. It is suitable as encoder for control variables, for example for electrical vent and mixing valves, valve positions, etc. The outputs can be output by means of standard objects via a BACnet client. Each output can be set for automatic or manual operation by means of 4 potentiometers at the front. The module is addressed and the baud rate is set by means of two address switches on the front. Suitable for decentralized mounting on DIN TH35 rail according to IEC 60715 in electrical distribution cabinets.

Connection with spring clamp terminal blocks (push-in)

BACnet is a registered trademark of ASHRAE. ASHRAE does not endorse, approve or test products for compliance with ASHRAE standards. Compliance of listed products to the requirements of ASHRAE Standard 135 is the responsibility of BACnet International (BI). BTL is a registered trademark of BI.

Technical Data

General Data

Protocol

BACnet MS/TP

Addressing range

00 to F9

Bus interface

RS485 (two-wire bus)

Transmission rate

9600 to 115200 bit/s

Operating voltage

24 V AC/DC +/- 10 % (SELV)

Current consumption

50 mA (AC) / 20 mA (DC)

Relative duty cycle

100 %

Outputs

4 x analog

Output / voltage

0 V to 10 V DC

Output / current

5 mA at 10 V DC

Output / resolution

0.3125 mV/digit

Display

Green and red LED

Dimensions (W x H x D)

35 x 69.3 x 60 mm

Weight

72 g

Operating temperature range

-5 °C to 55 °C

Storage temperature range

-20 °C to 70 °C

Ingress protection for housing / terminal blocks

IP40 / IP20

Check US distributor inventory

Accessories

Terminal block Type 259

Power supply NG4-F 24 V DC

Typ 135 RIACON 135_3.5

Accessory of

BMT-RTR BACnet-Router

BMT-F-RTR BACnet-Router

BMT-RTR/SC BACnet/SC Router

BMT-F-RTR/SC BACnet/SC Router

Part number

Part number:

110887130270

EAN:

4251394620664

Downloads

FAQ's

What can I do if the red ERROR LED on the module lights up or there is no communication?

There are several possible causes, please check the following:

- Operating voltage (A1 / A2) connected and sufficient for the device.
- BUS (A- / B+) connected and not reversed. Pay attention to (- / +), not to A/B.
- Address (rotary switches) set correctly, must not occur twice or be 0.
- Bit rate (rotary switches) set correctly, only possible in programming mode (see mounting note).
- Shielded and twisted pair cable used.
- Termination resistor (120 Ω) set on both sides.
- Bias resistors available once on the BUS.
- Max Master as high as the number of physical master I/Os on the BUS.
- Max Frame high enough for all answers from participants to get through (BMT-RTR setting).

Find contact person

Inquiry

Additional Information