BMT-F-RTR BACnet-Router
Description
BMT-(F)-RTR is a compact Router and enables bidirectional data exchange between BACnet/IP and BACnet MS/TP fieldbus devices. The BMT-(F)-RTR can be connected to METZ CONNECT BACnet MS/TP devices via two 4-pole terminals on the front of the device and a jumper plug. An integrated web server is used for parameter settings, management and monitoring of the two interfaces (Ethernet / RS485). The web interface is also used to update the firmware. The BMT-(F)-RTR is suitable for decentralised mounting in electrical sub-distribution boards or in control cabinets on TH35 mounting rails in accordance with IEC 60715.
- Connection with spring clamp terminal blocks (push-in)
- Access to 32 devices on the BACnet MS/TP bus
- Bidirectional exchange of data between BACnet/IP and BACnet MS/TP devices
- Protocol: BACnet MS/TP, BACnet/IP, BACnet Ethernet, HTTP 1.0
- Integrated web server
- Intuitive and software-independent TCP configuration via web interface
- Recording and analysis of IP and RS485 communication
- Simple device search of METZ CONNECT BACnet MS/TP devices on the RS485 bus
- Fast connection of METZ CONNECT BACnet MS/TP devices via proven jumper plug technology
BACnet is a registered trademark of ASHRAE. ASHRAE does not endorse, approve or test products for compliance with ASHRAE standards. Compliance of listed products to the requirements of ASHRAE Standard 135 is the responsibility of BACnet International (BI). BTL is a registered trademark of BI.
Technical Data
General Data
1 x Ethernet port (RJ-45 IEC 60603-7-51 (2010))
10/100 Mbits with auto-negotiation
BACnet IP, BACnet Ethernet, HTTP 1.0
BACnet MS/TP
9600 Bit/s to 115200 Bit/s
120 Ohm switchable
1,5 kV
24 V DC +/- 10 % (SELV)
50 mA
1.3 W
green LED
green LED (100 Mbit), yellow LED (10 Mbit)
green LED
35 x 69.3 x 60 mm
64 g
-5 °C to 55 °C
-20 °C to 70 °C
IP40 / IP20
Check US distributor inventory
Accessories
Accessory of
Part number
1108800170
4251394650227
Downloads
- Data sheet
- Brochure (BMT-AOP2 – Analog BACnet MS/TP output module for building automation)
- Brochure (BACnet/IP and BACnet/SC Router - Data Security with Secure Connect)
- 3D-Data - Registration required -
- Software (Firmware BMT-RTR V1.8 A1.1)
- Software (MC-Search Utility V3.3)
- Mounting note (Safety Instructions multilingual )
- Mounting note (11088001(70), 11088101(70))
- Software manual (BACnet Software-Handbuch PICS (BMT-RTR))
- Software manual (BMT-RTR Benutzerhandbuch)
FAQ's
Is the terminal block type 259 (110369) delivered with the BMT-RTR?
No, there are terminals on the device for this purpose (24V, GND, B+, A-).
Can the BMT-RTR be reset to factory settings?
Yes, via the jumper under the housing cover (see mounting note) or the web interface.
How many bus devices can I access with the BMT-RTR?
32, with 1 unit load per participant, most of our I/Os only have 0.125 load, which means that much more are possible depending on the conditions.
