Search form


DRIW-E16, 230 V AC

The speed and V-belt monitor is used for monitoring the rotary movement (insufficient speed) of motor and V-belt driven shafts. Inductive proximity switches are used for capturing the speed. Pulses are generated by the sensor without contact by means of driven control cams, toothed wheels, segmented discs, metal signal flags or similar. The relay is activated when the operating voltage is applied. After start-up bridging has finished, the monitoring function is started on the E1 and E2 terminals by means of the power contactor of the drive. When the drive speed falls below the switch-off speed, the relay is deactivated. The fault message of the speed or V-belt monitor is reset by means of the reset function and by switching off the operating voltage.

Operating voltage 230 V AC
Recovery time 400 ms
Type of monitoring Low speed
Max. monitoring range 4200 pulses/min
Switch-off range 120 pulses/min
Sensor input Two-wire
Start-up bridging 60 s
Outputs 2 changeover contacts (DPDT)
Output / switching voltage 250 V
Output / current 6 A
Output / total current 8 A / across all contacts
Display Green and red LED
Dimensions (W x H x D) 22.5 x 61.3 x 60 mm
Weight 70 g
Operating temperature range 0 °C to +55 °C
Storage temperature range -20 °C to +70 °C
Ingress protection for housing / terminal block IP40 / IP20

Technical Data 

  • P/N1101500522
    Feature 1230 V AC


lock ePLAN Daten 1101500522 1.77 MB
pdf Instruction 1101500522 1.3 MB
pdf Produktuebersicht C|Logline 899905-05 EN 4.58 MB
lock 3D data - STEP / IGES
2.65 MB
last update on Tuesday, 24. October 2017 - 3:53